...
Procedure for customizing stage settings
From the command bar, click File > Preferences.
Select the stage preferences options as described in the table below.
Click Ok.
| Info |
|---|
Click Default if you want to restore the original settings |
Stage Preferences options | ||
Tab | Parameter Name | Description |
|---|---|---|
General | Number of decimals for continuous values | Select the number of decimals that should be used when dealing with continuous valuesdisplayed for continuous values. This is only for graphical representation. To ensure high levels of precision, any operations involving continuous values will use the maximum number of decimal values available based on the machine CPU. |
Database compression level | Select the required database compression level to reduce the size of the database. | |
Check system memory to avoid paging | If selected, no memory paging is performed. | |
Stage | Grid step (X axis) | Set the width of columns on the stage grid. |
Grid step (Y axis) | Set the height of rows on the stage grid. | |
Show grid | If selected, grid-lines are visible on the stage. | |
Snap to grid | If selected, task automatically snap into position on the intersection points of the grid. | |
Pin magnet radius | Select the width of the area around the input and output pins of tasks which can be used to connect tasks. The input or output pins, used to connect tasks, can be selected by clicking in a circle where the pin is the center. The lower the Pin magnet radius value, the closer to the pin you have to click, the higher the value the wider the "sensitive” area becomes. | |
Show task names | If selected the name of each task in the process is displayed in the stage. | |
...